Hi Rollers Articles

DIY Misting Cooling Fan

The following instructions show you just how to put in place a mist system ring on a moveable home fan to make your own fan misters. This set up allows you to produce an practical mist fan employing the water pressure out of your yard water faucet. It’s fantastic for cooling down 1-2 people on your outdoor patio. It can additionally be put to use to cool off your dog or other pets, or even a small rabbit hutch or chicken coop.

Just what you’ll need:

• Low water pressure misting fan adapter package (includes low pressure line, hose bib adapter, zip ties, 1/4-inch push lock connector for the misting ring).
• Misting Hoop with low-pressure nozzles
• Fan – Sixteen inches or wider
• Electrical Outlet with a ground fault circuit breaker
• Power cord extension
• Close by hose bib water faucet.

The faucet connector should already be installed on the hose, but if not, just put the tubing into the little side of the adapter. It can be a snug fit, thus in the event that you experience difficulty performing this manually, make use of pliers to help drive the tubing in.

In the event that you acquired a misting fan kit with a mist ring, a push lock fitting for 1/8-inch tubing will already be fitted on the ring. If you got the mister fan kit separately, it comes with a fitting that you will have to put in on your mist ring. In case the connector doesn’t have plumber’s tape wrapped about it, you will have to wrap the male end 2 to 3 times, then install the connector into the mister ring.

Press the hose firmly into the connector, then gently tug back to be sure the tubing is tight in the connector.

For our demonstration, I’ll be using low cost box fan I purchased at Lowe’s a few years ago. Set the fan down, then center the misting ring on top of the exhaust side of the fan, with the mist nozzles directing away from the fan.

Affix the misting ring to the fan using ties that came with the low-pressure mist fan kit. Bend over the zip tie first, which will make it much easier to thread in and around the ring and the grill of the fan shroud. Pull the ties snug, then snip off the ends to keep it tidy. You can set the fan up-right now, making sure the mist ring is secure.

Plug the fan into a ground fault protected electric outlet. A Gfci outlet is the variety with a black “Test” and a red “Reset” button. These kind of outlets bread the circuit when there is a “ground fault,” which happens whenever the electric current finds an alternative path to ground. For example, it might try to travel through your body if you are foolish enough to be standing in a puddle of water. Don’t be dumb – always be extremely cautious when working with electrical power in the presence of water. In modern-day homes, electrical outlets on the outside of the house are typically on a ground fault circuit or are ground fault outlets. In many homes, the entire GFCI circuit is managed by a ground fault wall socket in the garage. Always be sure to verify that it is functioning properly prior to plugging in your misting fan.

Attach the tube with the water faucet adapter to the water faucet.

After plugging the fan in and turning it on, you should turn on the water to begin the misting. Now you may cool off with your personal mist fan!